I recently had my jet pump “stop” working. I didn’t know where to look as I had never had this happen, and had to go find the fix on the Internet. To give you an idea of what I was contending with, see the picture below.
From there, I still had no idea how to configure this thing to start working so then I had to go check out this video (which was immensely helpful in explaining the product).
Important to note in the above picture are those two springs and the nuts on top of them. To configure the PSI to your pump, you need to play around with those screws to configure the shut on/off of the pump.
The design is only intuitive if you work in mechanical or work in pumps. When implemented (I hope based on the last one), it will work for another 9 years.
There is no AI in Mechanical work; people put these videos together and share them. AI might point me to them, but people did the work.
